Remember
The SodaStream ensō™ sparkling water maker is ONLY compatible with the SodaStream CO2 Quick Connect Cylinder and is NOT compatible with the SodaStream CO2 Screw-in System Cylinder or other cylinders.
- Place SodaStream ensō™ Sparkling Water Maker on a flat sturdy surface.
- Gently pull the plastic carbonating bottle towards you until it reaches its fully forward position. This will allow the plastic carbonating bottle to be released from the Snap-Lock mechanism.
- Remove seal and cap from the SodaStream CO2 Quick Connect Cylinder. WARNING! Never insert or replace the SodaStream CO2 Quick Connect Cylinder while a Carbonating Bottle is installed in the Sparkling Water Maker. This can cause the Carbonating Bottle to be ejected or burst.
- Raise the cylinder handle.
- Open the cylinder compartment.
- Insert the SodaStream CO2 Quick Connect Cylinder into the cylinder compartment of the Sparkling Water Maker.
- Close the cylinder compartment.
- Lower the cylinder Handle.
- Place the drip tray on the base of your Sparkling Water Maker.
- Cylinder exchange can be made at a retail location or online.
Any questions? Contact us via email or phone 0800 – 0223637.